PUMPST  P

STOP WELL PUMP MELTDOWNS!

PUMP OVERHEAT PROTECTION SWITCH INSTALL INSTRUCTIONS:


Find us on Amazon.com

   FEATURES:

  1. Locate flat and clean area on pump where the Pump Overheat Protection Switch will be placed.
  2. Twist and blend ribbon epoxy until colors blend thoroughly and turns green. (below fig 1)
  3. Place equal amounts on Pump Overheat Protection Switch (below fig 2) within 2 minutes of mixing.
  4.  Press Pump Overheat Protection Switch firmly against pump with a slight twisting motion making sure sensor is in contact with pump. Pump Overheat Protection Switch will stay in place until epoxy hardens. (10 - 20 minutes) full cure (4 - 5 hours). (above in fig 3)

 

Fig 5

5. Electrical wiring directly (in line) to either one of the power supply lines (L1 OR L2) at the relay OR the pressure switch OR at the motor or pump station controller. 24-120-240 volts 30 amps max. below fig 4 & 5

Call Today: 321-305-9331

MADE IN THE U.S.A.

Copyright (c) Pump Overheat Protection Switch 2020 Web Design: Rhinostudio.com

All rights reserved, including the right of reproduction in whole or in part in any form.

Made with Adobe Muse