PUMPST  P

STOP WELL PUMP MELTDOWNS!

PUMP OVERHEAT PROTECTION TECH SHEET:


Find us on Amazon.com

USES

Pump overheat damage is caused when water stops flowing and the pump continues to run. This causes the water in the pump to get very hot resulting in total system failure. The POP 120 shuts off the pump before OVERHEAT DAMAGE OCCURS, keeping the pump system safe until repairs can be made.

FEATURES:

  1. Automatic shut off / Automatic reset
  2. Works on all jet or centrifugal pumps
  3. High grade insulated poly exterior box
  4. Mounts in any position (even upside down)
  5. High tech twist adhesive for easy installation
  6. Water resistant (use indoor or outdoors)
  7. Heavy duty U.L. and C.U.L. Approved thermostat

 

PROTECTS AGAINST:

  • Lost Prime
  • Pressure Switch Failure
  • Broken Valves
  • Stuck Relays
  • Low Water Table
  • Even User Error

ELECTRICAL SPECIFICATION:

  • Application Suitable for 24-120-240 VAC
  • Switch electrical rating: 30 amps @ 120-240 VAC
  • Wire: 32" length of #14/2 conductor extension wire
  • Not recommended for use on submerged pumps

DIMENSIONS:

  • Overall height: 2-7/8"
  • Overall width: 1-7/8"
  • Depth: 1-1/2"
  • Wire length: 32"

Easy to install in minutes

MADE IN THE U.S.A.

General Contracting Services

P.O. Box 631

Cocoa Beach, Fl. 32932

321-333-9887

PUMPSTOPnow.com

Call Today: 321-305-9331

MADE IN THE U.S.A.

Copyright (c) Pump Overheat Protection Switch 2019 Web Design: Rhinostudio.com

All rights reserved, including the right of reproduction in whole or in part in any form.

Made with Adobe Muse